LED Light Bar Wiring Harnesses

WIRING & CONTROL

A harness carries the current from the battery to the lamps. The current range and the operating voltage are published on all eight models. The recommended load, which says how much lamp the harness is meant to feed, is on seven of them; the wireless-controller model does not list a recommended load.

Two harnesses can look identical and be rated for very different loads, so choose by the total wattage on the circuit.

Recommended load40 W to 0–100 W depending on model
Current range0–8 A, 0–10 A and 0–30 A depending on model
Voltage12 V, 12–24 V and 12–60 V models
ControlWired, wireless and app control

What decides the specification

Total load first

What to checkAdd the rated power of every lamp on the circuit, then choose a harness whose recommended load is above that total.DXZ range on this page40 W, 80 W and 0–100 W ratings in the range

Voltage range

What to checkA 12 V-only harness is not a 24 V harness. Match the harness to the vehicle, not to the lamp.DXZ range on this page12 V, 12–24 V, 12–60 V

One or two leads

What to checkA dual-lead harness runs two lamps or two circuits from one controller; a 1-to-2 harness splits one output.DXZ range on this page2-in-1 and 1-to-2 configurations

Control method

What to checkWired controller, wireless remote or app control. The control method decides where the switch goes and whether a receiver needs power.DXZ range on this pageWired, wireless, app

Wire gauge and fusing

What to checkThe wire specification and the supplied fuses set the real limit. Check both against the load.DXZ range on this page18 AWG to 2×0.75 mm², 3 fuses supplied on the 30 A model

Models compared

Products in this range

How to read the ratings

  • Recommended load is the figure DXZ publishes for the harness. It is not the same as the current rating, and the two should be read together.
  • A 12 V 30 A harness with a 0–100 W recommended load is intended for lamps up to about 100 W total, even though the contacts and fuse are rated higher.
  • None of these harnesses carries a certification claim on its product page. Do not specify them as E-marked or type-approved components.
  • For a lamp with a short flying lead, the harness supplies the run to the switch and battery; it does not replace the lamp’s own cable.

Questions buyers ask

Which harness do I need for two 24 W work lights?

48 W total. The 12–24 V harness with an 80 W recommended load or the 12 V 30 A harness rated 0–100 W both cover it; the 40 W harness does not.

Is a 30 A harness suitable for a 300 W bar?

No. The recommended load on the 12 V 30 A harness is 0–100 W. A 300 W bar needs a different solution, not a higher fuse.

Can I use the same harness on a 24 V machine?

Only if the harness is rated for it. The range includes 12–24 V and 12–60 V models; the 12 V models are 12 V only.

Do the harnesses include a relay and fuse?

The 12 V 30 A model is supplied with blade terminals and three fuses. Check the ‘included control / hardware’ row for each model.

Are these harnesses certified?

No certification is listed for the harness range. They are supplied as vehicle wiring accessories, not as type-approved components.

Related ranges and guides

Request a quotation

Send the harness model, the total load on each circuit and your supply voltage. We will reply with the harness that matches those numbers and a quote.

Start an enquiry